Start Binding - Horizon Fitness BQ-270 Manual

3-8 Start Binding

When 10 minutes has passed after the drum is
stopped, message to rotate the drum appears. Press
the button on the Single Operation Screen Part
1 to check that the glue is heated to the setting temper-
ature and melted completely.
WARNING
- Do not put your hand inside the machine
when the carriage clamp is operating. This
part can cause severe personal injury.
- When feeding a book block, remove your
hand from the carriage clamp before it
moves. This part can cause severe per-
sonal injury.
Binding Operation Flow
Insert book block
inside the carriage clamp.
If the milling operation
is turned ON, the book
spine is milled here.
Glue is applied to the
book block by the melt
tank.
The nipping section presses
the book spine and the
cover sheet.
After the carriage clamp
comes back above the
level plate, the booklet is
delivered to the delivery
section and stacked.
Press both start buttons to rotate
the milling cutter.
- The drum motor starts turning.
Insert a book block in the carriage
clamp and push it to the right.
Start the binding operation.
- Press both Start buttons.
45