Glue Adjustment; Stirring Glue In The Tank - Horizon Fitness BQ-150 Manual

2-2 Achieving Good Quality Binding

(4) Glue Adjustment

CAUTION
- Only perform glue adjustment while
the glue is melted.If adjustment is
attempted when glue is not completely
melted,the machine can be damaged.
-When binding with a cover, set the glue
adjusting knob between positions 1 and 2.
-When binding a thick book (a book thick-
ness of about 2 to 3 cm) with a cover, set
the glue adjusting knob to further than 2
to ensure strong bonding.
-When binding a thick book (book thick-
ness of about 2 to 3 cm) with tape or
padding, set the glue adjusting knob
between positions 0 and 1 to get clean and
neat binding.

(5) Stirring Glue in the Tank

Hot-melt glue may not be applied to a book
block evenly in case temperature of glue in the
tank is uneven (right after the glue is melted). In
such case, follow the procedure below to stir the
hot-melt glue and improve uneven temperature
of glue in the tank.
1.
Turn on the power switch and wait for the
reset lamp to light which shows that the hot-
melt glue is ready for binding.
2.
Press the reset button.
- The clamper close button blinks.
3.
Select "padding (binding without cover)"
with the binding mode selector switch.
Reset Button
Clamper Close Button
Padding
Perfect Binding
(Binding with cover or tape)
Binding Mode Selector Switch
21
2. Operation Procedure
Glue Adjusting Knob
Reset Lamp