Cover Sheet Angle Adjustment - Horizon Fitness BQ-270 Manual

4-12 Cover Sheet Angle Adjustment

When the cover sheet is out of position, adjust the
angle of the registration stopper.
Check that the cover sheets are cut correctly before
doing this adjustment. If the cover sheets for the current
job are not square, make a temporary adjustment to fin-
ish the job. Remember to reset the angle adjustment
when the job is finished.
Open the lower nipper door.
Loosen the locking nut on the angle
adjusting lever.
Loosen the locking knob.
- Loosen the locking knob on the registration
stopper angle adjusting lever.
Locking Nut
Registration Stopper
Angle Adjusting Lever
Locking Knob
66
Adjust the angle of the cover sheet.
- Turn the adjust knob clockwise, and the cover
sheet will rotate to the left.
- To move the lever to the left, push the lever to
the adjust knob and turn the adjust knob
counterclockwise.
Adjust Knob
Registration
Stopper Angle
Adjusting Lever
Cover
Tighten the locking knob and the
locking nut, then close the lower
nipper door.