Binding Screens - Horizon Fitness BQ-270 Manual

2-2 Bind the Books Using the Binding Screens
1
-
The current job information and the production conditions are displayed here.
1
2
3
4
1
Binding Counter/Pre-set Counter. Press
press the counter box and input the new pre-set number using the Numeric Keypad Screen. Press the
right part of the pre-set counter (
This adjusts the production speed (carriage clamp moving speed) in five steps.
2
: Slow down
This indicates the book block thickness already entered on the Setting Screen.
3
This indicates the distance between the cover sheet edge and the spine already entered on the Setting
4
Screen.
When using a saved job, the job number appears here. When not using a saved job or the read memory
has been changed, 0 is indicated here.
5
This area displays the production conditions.
6
Press this button to lower the feed table.
7
Press this button to feed one cover sheet. The machine memorizes the cover sheet thickness in order to
detect the double feeding.
8
This button is used to stop the motor on each unit after the binding operation. (Before the motor drives,
start icon is indicated.) Press this button before switching the power off.
9
Status Monitor
10
: This symbol will appear when the cover sheet is fed to the nipping section, and the book block is
put in the carriage clamp.
:This symbol will appear if a cover sheet is not fed automatically to the nipping section. Feed a cover
sheet by pressing both start buttons.
Booklet is not delivered within 2 seconds after the carriage clamp has opened.
Double feeding
No cover sheet on the feed table. Set the cover sheets.
Pre-set number of binding is finished.
###
OK
Milling ON/OFF lever Error
Remove cover sheet on nipper.
Main Binding Screen
10
Binding Counter
00000
6
5
9 8 7
C
to clear the counter. To change to the pre-set counter,
) and input 0 to return to the binding counter. See figure above.
Misfeeding
19
30
Pre-set Counter
0000 0030
C
0
: Speed up
In operation Delivery section full
Insert Book Block
Press start button to drive the motor.
Remove cover sheet at double feed detect sensor.