Horizon Fitness BQ-270 Manual page 43

3-3 Enter the Job Information Using the Setting Screen
Select the spine gluing and side
gluing settings.
- Input the spine glue and side glue settings
using the Glue Screen. Refer to page 16.
- If you are using spine glue or the side glue,
adjust the glue amount using Part 2, 3 and 4
of the Gluing Screen. Refer to pages 16 and
17. (The glue amounts can also be adjusted
using the Fine-adjust Screens.)
Input the cover sheet size.
- Input the cover sheet length and width, and
the distance between the cover edge and the
spine. Refer to page 13.
Turn the double feeding detect
function ON or OFF.
- Turn the double feeding detect function ON or
OFF using the Function Screen. Refer to page
14.
Input the milling and nipping set-
tings.
- Select the type of milling and nipping using
the Milling, Nipping Screen. Refer to page 15.
- To select milling OFF, select
check that the milling ON/OFF lever is set to
the left (OFF).
- To select milling OFF, select
check that the milling ON/OFF lever is set to
the right (ON).
- When using saved job information, go to
page 49.
Without Milling
37
. Also
. Also
Milling Select Lever
With Milling