Fine Adjustment; Clamp And Milling Fine-Adjust Screen - Horizon Fitness BQ-270 Manual

2-4 Fine Adjustment

3
- -
You can use this screen to make fine adjustments to the carriage clamp width and the
milling guide width.
1
2
Adjust the carriage clamp opening amount so that the book block is inserted
1
smoothly. Unless you make this adjustment, the carriage clamp opens just the same
amount as the book block thickness. Increase the opening to match the type of the
book block. The input range is 0 to +15.0 mm (+0.590").
: Makes the carriage clamp width wider. (Use this when using signatures.)
: Makes the carriage clamp width narrower. (Use this when using sheets which
crease or tear easily.)
Adjust the opening so that the book block can move into the carriage clamp easily
without being disturbed. After the adjustment, check that there is enough carriage
clamp pressure by pressing the Carriage Clamp Close button on the Single Operation
Screen.
Adjust the milling guide width. The input range is 0 to +10. 0 mm (+0.395").
2
This adjustment may be necessary when using signatures. (Signatures can cause the
spine of the book block to swell and hit the milling guide.)
: Make the milling guide wider.
: Make the milling guide narrower.
When using signatures, make the milling guide wider to give the spine a good finish.
However, if the guide is set too wide, the spine will be allowed to expand too much.
Clamp, Milling Width Adjustment
Clamp and Milling Fine-Adjustment Screen
21