Table of Contents
Advertisement
V7.x Packet Controllers
PCX/PCX-2 Hardware Settings
To LIM1
(Lower Slot)
PCX/PCX-2
Base Card
S1
Table 4-2
PCx Controls and Indicators
Items
Designation Description
Front Panel
FLT LED
Status LEDs
RUN LED
LNK FLT
Front Panel
MGMT
Ports
USER
GbE 1/2
FE 1 - 8
On-board
P3
Jumper
On-board
S1
(See
Rotary Switch
(16 position)
Figure
4-3)
Note
IMPORTANT ! Be aware that when S1 is set to F, all user configuration files and XOS code will be erased
from the card. This setting should be used with caution, and you must reset S1 back to 0, 4 or 8 immediately
after reboot to prevent inadvertent erasure with subsequent reboots.
Note
Additional S1 settings can be used to reboot the card to kernel for troubleshooting purposes, under the
guidance of your authorized Xedge field service representative.
032R440-000
Issue 17
To LIM2
(Upper Slot)
To Switch
Fabric
LPM
Daughter Card
(LPM types -1 thru -6)
3
P3
1
PCX/PCX-2 Front Panel
FLT (red) is normally off; Lit when a problem prevents the Slot Controller from functioning.
RUN (green) illuminates when the Slot Controller is powered on and operating.
LNK FLT (red) is not supported in this release.
10/100 8-pin modular jack connects to Prosphere Server or ProSphere Server network.
10/100 8-pin modular jack connects to Ethernet network.
Two Gigabit Ethernet ports; GbE1/2 LEDs indicate active connection when lit.
Eight 10/100 Mbps Fast Ethernet ports: Left LED indicates 100 Mbps operation when lit.
Right LED indicates active connection when lit.
Only for use in factory tests. For normal operation, this jumper must be set to
Pins 2 and 3, as shown above.
Set to 0 when PCx is in main slot 0 and slot 1 of Xedge 6160/6280.
Set to 0 when PCx is in standby slot 0 and slot 8 of Xedge 6640/6645.
Set to 8 when PCx is in non-slot 0 of any chassis (slot 0 must be a packet controller).
Set to F to delete all user-defined configuration files and XOS code (i.e. to factory default)
Xedge 6000 Hardware
Installation & Setup Guide
PCX/PCX-2 Controller Overview
BACKPLANE
To
CONNECTORS
Backplane
NETWORK PROCESSOR
Daughter Card
2xGbE
8xFE
1
GbE
1
GbE1
GbE2
1
2
5
5
FE
4
4
8
8
4-7
Advertisement
Table of Contents
