Table of Contents
Advertisement
Line Interface Modules
T1/E1 MP16 LIM
The T1/E1 Multi-Protocol LIM is a 16-port LIM intended for use with the PCx-2 slot
controller. It supports T1 data rates up to 1.544 Mbps, and E1 data rates up to 2.048
Mbps.
Front Panel Features
The front panel connectors provide easy access to the ports. The front panel LEDs
indicate LIM communication status. All LEDs are controlled by the slot controller
software:
•
RUN LED illuminates when the link is in-service.
•
ALARM LED illuminates during loopback tests; Blinks when the link
hardware detects an out-of-frame error on the receive line.
Front Panel Connectors
•
LINK 0-15 is a female 68-pin amplimite connector for attaching external
communication devices to links 0 through 15.
•
Table 5-4
and lists the pinouts.
•
An optional 16-port (RJ48) T1/E1 Distribution Panel (S-032A011-002xx) can be
used with the above cable.
Hardware Setup
Jumpers
Jumpers on the T1/E1 MP16 LIM are for factory use only.
Installation
The T1/E1 MP16 LIM occupies a rear panel slot of the switch that is associated with
the corresponding controller. When handling LIMs, always use an antistatic wrist
strap to prevent static discharge damage to the electronic circuits.
1. Install the LIM into an empty slot at the back panel of the chassis.
2. Insert the edges of the module into the tracks of the slot and slide the module
inward until it stops. (LIMs are "hot-swappable".)
3. Connect the appropriate I/O line(s) to the LIM's front panel input connectors
using the proper cables.
4. Refer to the Xedge Configuration Guide to properly configure the LIM for your
application.
Figure 5-6
032R440-000
Issue 17
shows the 68-pin male to dual 50-pin RJ48 male cable (027H703-008)
Table 5-5
T1/E1 MP 16 LIM Front Panel Features
Xedge 6000 Hardware
Installation & Setup Guide
shows panel pinouts.
T1/E1 MP16 LIM
T1/E1
MP16
5-11
Advertisement
Table of Contents
