General DataComm Xedge 6000 Series Hardware Installation page 143

Line Interface Modules
Optional 120 Ohm E1 Distribution Panel Kit
The optional 120 Ohm E1 Distribution Panel Kit (032M164-001) is used with the E1 IMA/IMA+
LIMs only and contains the following components:
• Two 120 Ohm, 25-Twisted Pair, Shielded Cables (025H602-006)
• One RJ48M to RJ48C Distribution Panel (S-032A011-002xx)
E1-IMA LIM
(not supplied)
RX (in)
TX (out)
chassis
ground
= Twisted Pair
= Connection
TX = Transmit
RX = Receive
Figure 5-23
Note
Distribution panel pinouts are described in
032R440-000
Issue 17
120 Ohm
25-Twisted Pair
Shielded Cable
025H602-006
1-Ring 1-Ring
26-Tip 26-Tip
3
2-Ring 2-Ring
27-Tip 27-Tip
28
shield
50-pin Telco
connectors
Connection Diagram, 120 Ohm E1 Distribution Panel Kit (one link shown)
Table
Xedge 6000 Hardware
Installation & Setup Guide
DSX-1 and E1 IMA/IMA+ LIM Overview
E1 Distribution Panel
S-032A011-002xx
RX
3 RX shield
TX
28
TX shield
chassis
ground
5-5.
120 Ohm
4-Twisted Pair
Shielded Cable
(not supplied)
1, 2 1, 2
3 3
4, 5
4, 5
6
6
shield
RJ45
connectors
5-41