Xedge 6002 Front/Rear Panel Features - General DataComm Xedge 6000 Series Hardware Installation

Xedge Chassis Systems

Xedge 6002 Front/Rear Panel Features

The Xedge 6002 chassis has no provision for a switch fabric module; therefore, only packet-based
controllers (Table
The front panel can accept one double-width packet controller (e.g. Xedge PCX, PCE or PCL). The
rear panel can accept one or two LIMs that connect to the controller at the midplane. As an
alternative, a single-width packet controller (e.g., Xedge ISG2) can be installed in slot 0, with an
additional compatible controller installed in slot 1, such as the Xedge CE, ACP, VSM, or another
ISG2.
The Fan Tray assembly and the Fan Filter assembly are mounted on right and left side rails inside
the chassis, and can be removed/replaced from the chassis front panel. The Xedge 6002 is supplied
with an electrostatic discharge (ESD) wrist strap that attaches to the front panel jack on the chassis.
A management (CRAFT) port is also located at the front panel, as shown in the figure below.
The power panel and fuse compartment are also located at the rear of the chassis.
Xedge 6002 Chassis
Front Mounting
Brackets
(Left & Right)
Rear Mounting
Brackets
(Left & Right)
Detail Views
DETAIL A:
Power / Fuse Panel Label
General DataComm
MODEL:
Ground
THIS ENCLOSURE MAY CONTAIN FCC REGISTERED EQUIPMENT.
Screw
SPECIFIC REGISTRATION INFORMATION IS CONTAINED
ON INDIVIDUAL UNITS.
Figure 2-1
032R440-000
Issue 17
1-1) can be installed in slot 0 since they have the fabric sufficient for this chassis.
Fan Filter
Assembly
SLOT 1
SLOT 0
Power / Fuse
Panel
Detail A
AC POWER, 100-240VAC, 1A, 50/60 Hz
Naugatuck, Ct. USA
XEDGE 6002
For continued protection
against fire or shock
replace only with
F1.6A, 250V fuse
ON/OFF
Switch
Xedge 6002 Chassis, Front and Rear Views
Xedge 6000 Hardware
Installation & Setup Guide
Front View
Slot Controller Module
Slot Controller Module
Connector for
Antistatic Wrist Strap
Rear View
LIM 2
LIM 1
See See
Detail B
1
0
Fuse AC Power
Compartment Connector
Xedge 6002 Chassis
Fan Tray
Assembly
1
Management
0
(Craft) Port
CRAFT
DETAIL B:
W.E.E.E Label
Ground
Switch
2-3