Table of Contents
Advertisement
Switch Fabric and V6.2 Controllers
XH/XS Switch Fabric Hardware Setup
The Xedge XH Switch Fabric module is intended for use in the Xedge 6640 and Xedge 6645
chassis. The XS Switch Fabric module intended for the Xedge 6280 chassis. Onboard jumpers
control XH/XS traffic priority and modes of operation: XH mode (50 MHz), or XP mode (25 MHz).
The jumpers on the XH/XS Switch Fabric must be configured or checked before installing the
module in the chassis.
pairs on each jumper. Hold the board as shown with the component side facing you and the front
panel to the left. In this position, references to "upper" or "lower" in the table are the "upper" or
"lower" jumper positions.
FRONT PANEL
Figure 3-4
032R440-000
Issue 17
Figure 3-4
and
Table 3-4
XH/XS CIRCUIT BOARD
JP2
JP4
JP1
JP3
XH/XS Jumper Locations
Xedge 6000 Hardware
Installation & Setup Guide
Switch Fabric Setup
show the location and describe the function of pin
LEGEND
Jumper in upper position.
Jumper in lower position.
3-9
Advertisement
Table of Contents
