Ce Hardware Settings - General DataComm Xedge 6000 Series Hardware Installation

Switch Fabric and V6.2 Controllers

CE Hardware Settings

The jumpers on the CE slot controller must be configured or checked before installing the module
in the chassis.
jumper. Hold the board as shown with the component side facing you and the front panel to the left.
In this position, references to "right" or "left" in the table are the "right" or "left" jumper positions.
FRONT PANEL
Table 3-2 CE Slot Controller Jumper Settings
Jumper Position
JMP1 Right
JMP6 1, 2, 4, 7
JMP2 Right
Left
JMP10 Right
Left
032R440-000
Issue 17
Table 3-2 and the accompanying figure describe the location and function of each
CE CIRCUIT BOARD
JP2
JP1
JP3
Not used
Pos. 1
JP6
ROTARY
SWITCH
Pos. 8
Functions
Mandatory setting; do not change position.
Mandatory setting as shown in figure; do not change.
Determines PROM and flash EPROM size compatibility.
Selects 50 Mhz operation.
Selects 25 Mhz operation.
S elects XP mode.
Selects XH mode.
Xedge 6000 Hardware
Installation & Setup Guide
Slot Controller Setup
JP10
Slot 0 DOC
(Daughter Option Card)
Comments
JMP2 and JMP10 are codependent. Set 50 MHz
with XH or 25 MHz with XP . When CE controller
is in a switch with controllers operating only at
the 25 MHz rate, the CE controller must be set to
operate in XP mode at 25 MHz.
LEGEND
Open pins;
Not covered by jumper.
Jumper in left position.
Jumper in right position.
3-5