155 Series Jumper Settings - General DataComm Xedge 6000 Series Hardware Installation

Line Interface Modules

155 Series Jumper Settings

There are no user-selectable jumpers on the 155 series LIM. The X1 jumper shown in the figure
below is for factory use only. It is shown here for reference only. The Normal (store)
position shown (Pins 1 and 2) is just for storing the jumper. That is, removing the jumper from this
"store" position has no effect on the operation of the LIM.
Figure 5-14
5-24
3
2
1
155 Series OC-3c/STM-1 Optical LIMs Jumper Position (155M-APS shown)
Xedge 6000 Hardware
Installation & Setup Guide
155 Series LIMs Overview
Boot Jumper
For Factory
Use Only
Load Software
Jum p P ins 2 & 3
Norm al (store)
Jum p P ins 1 & 2
(norm al show n)
032R440-000
Issue 17