General DataComm Xedge 6000 Series Hardware Installation page 140

Line Interface Modules
Standard Cabling
The IMA LIMs are supplied with two 25-twisted pair cables for transmit/receive tip and ring
signals. The LIMS are supplied with cable tie wraps for securing the cable connectors to the LIM
connectors opposite from the retaining screw as shown in
Figure 5-20
Optional cabling schemes for IMA LIMs are described in the following paragraphs:
• Optional T1/E1 8-Port Break-out Cable Assembly
• Optional DS1 Distribution Panel Kit
• Optional 120 Ohm E1 Distribution Panel Kit
• Optional 75 Ohm E1 Distribution Panel Kit
Note
IMPORTANT! For all IMA applications, refer to
(Figure 5-25) to comply with all domestic and international standards.
5-38
Standard Cabling Installation (shown from LIM connector side view)
Xedge 6000 Hardware
Installation & Setup Guide
DSX-1 and E1 IMA/IMA+ LIM Overview
Figure 5-21.
R etaining
S crew
C a ble T ies (qty 2 )
A s S how n (2 p lcs)
C able
Class A EMI-RFI Suppression Requirements
C on nector
H o usin g
Install S u pplied
032R440-000
Issue 17