Xedge 6280 Chassis; Technical Specifications; Module Installation - General DataComm Xedge 6000 Series Hardware Installation

Table of Contents

Advertisement

Xedge Chassis Systems

Xedge 6280 Chassis

Xedge 6280 is a 7-slot chassis that allows full redundancy by employing main and standby slot-0
controllers, main and standby switch fabric, and backup power supplies. It also accommodates one
Network Timing Module (NTM) for advanced system timing configurations. The Xedge 6280 is
available in AC and DC power source versions. The AC-version autoranging power supplies
automatically adapt to AC power inputs ranging from 90 to 264VAC. For detailed specifications,
refer to the table below.
An optional Front Door Kit (P/N 010K386-001) is also available. In cabinet/rack-mount
installations, the door may be removed if it interferes with equipment installed below the chassis.

Technical Specifications

Table 2-6
Xedge 6280 Chassis Technical Specifications
Xedge 6280, AC Version (P/N 010B209-001), GPS-16A AC Power Supply (P/N 035B011-002)
Input Voltage Range
Input Frequency
Maximum Power Consumption
Service Current Requirement
Fuse Rating
Heat Dissipation
Xedge 6280, DC Version (P/N 010B210-001), DPS-16A DC Power Supply (P/N 041B011-001)
Input Voltage Range
Maximum Power Consumption
Fuse Rating
Heat Dissipation
Dimension (H x W x D)
Weight
Temperature, operating
Temperature, non-operating
Humidity
Altitude, operating
Altitude, non-operating
Compliance

Module Installation

Refer to Chapter 3, Switch Fabric and V6.2 Controllers for procedures on how to properly install
and remove modules in and out of the Xedge 6280 chassis.
Note
IMPORTANT! To avoid equipment damage, install only supported Xedge modules in appropriate slots of the
Xedge 6280 chassis. Refer to
032R440-000
Issue 17
90 to 264 VAC
50 to 60 Hz
750 W (with 2 power supplies)
15A
6.3A, 250 VAC, each power supply
2,388 BTU/hr, maximum
-42 to -70 VDC
750 W (with 2 power supplies)
10A, 250 VAC, each power supply
2,388 BTU/hr, maximum
Xedge 6280, AC and DC Version
8.75 in (22.2 cm) x 17.7 in (45 cm) x 19.25 in (48.9 cm)
With desktop feet installed, add 0.65 in (1.65 cm) to Height.
35.5 lbs (16.1 kg) with fans, 2 power input modules, 2 power supplies
66 lbs (29.93 kg), fully loaded
32 to 122 deg. F (0 to 50 deg. C)
-40 to 158 deg. F (-40 to70 deg. C)
Up to 95% without condensation
0 to 10,000 ft (0 to 3,047 m)
0 to 40,000 ft (0 to 12,191 m)
CISPR 22 Class A, UL Listed (UL1950), c-UL Listed (CSA C22.2
#950), TUV licensed (EN60950), CE Mark
Table 1-1
and
Table 1-4
before installing any modules.
Xedge 6000 Hardware
Installation & Setup Guide
Xedge 6280 Chassis
2-17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xedge 6280Xedge 6160Xedge 6645Xedge 6002Xedge 6640

Table of Contents