Front/Rear Panel Features - General DataComm Xedge 6000 Series Hardware Installation

Xedge Chassis Systems

Front/Rear Panel Features

The Xedge 6280 front panel can accept one or two slot-0 modules (main/standby), one or two
switch fabric modules (main/standby), and up to six additional slot controller modules (slots 1
through 6). The Fan Tray is located to the right of the module slots. The Xedge 6160 is supplied
with an electrostatic discharge (ESD) wrist strap that attaches to the front panel jack on the chassis.
The rear of the chassis can accept up to eight LIMs and one System Management Module (SMM),
which provides two management (CRAFT) ports. There are two slots for Power Input Modules
(PIMs) and four slots for Power Supply Units 0-3:
3: Backup Standby Backup
2: Backup Main Power Supply
1: Standby Power Supply
0: Main Power Supply
This power arrangement can support power input and power supply redundancy.
Mounting
Brackets
Figure 2-6
Note
Two rear panel slots are intended for SMM and NTM modules. Refer to Chapter 6, Network Timing Modules
and Chapter 7, System Management Modules for details
2-18
Front View
SLOT 6 Slot Controller Module
SLOT 5 Slot Controller Module
Slot Controller Module
SLOT 4
SLOT 3 Slot Controller Module
SLOT 2
Slot Controller Module
SLOT 1 Slot Controller Module
SLOT 0 Main Slot Controller Module
Switch Fabric
Switch Fabric
SLOT 0 Standby
Slot Controller Module
POWER SUPPLY
3 BACKUP STANDBY
PIM B
POWER SUPPLY
2 BACKUP MAIN
POWER SUPPLY
1 STANDBY
PIM A
POWER SUPPLY
0 MAIN
Rear View
Xedge 6280 Chassis, Front and Rear Views
Xedge 6000 Hardware
Installation & Setup Guide
Xedge 6280 Chassis
FAN
TRAY
6
5
4
3
2
1
0
ESD
SF
SF
(STDBY)
0
(STDBY)
SLOT 6 LIM
SLOT 5 LIM
SLOT 4 LIM
SLOT 3 LIM
SLOT 2 LIM
SLOT 1 LIM
SLOT 0 LIM (Main)
SMM
NTM
SLOT 0 LIM (Standby)
Connector for
Antistatic Wrist Strap
032R440-000
Issue 17