General DataComm Xedge 6000 Series Hardware Installation page 52

Xedge Chassis Systems
Power Supply Installation
To install a new power supply, perform the following steps:
1. Turn off the POWER switch of the power supply you are installing.
2. Select the slot you wish to use for the installation of the power supply. If you plan to install
two power supplies in the chassis, then you must install them in the Main A and Main B power
supply slots.
3. Remove the blank panel that covers the slot by loosening its two retaining screws.
4. Carefully insert the power supply into the tracks of the slot.
5. Slide the power supply into the slot until its front panel bottoms out on the chassis.
6. Tighten the two captive screws on the front panel of the power supply.
7. Turn on the POWER switch of the power supply.
Note
The power supplies have no hardware options.
Replacement Procedure
To replace a power supply, perform the following steps:
1. Turn off the POWER switch of the power supply you are replacing.
2. Loosen the two captive screws on the front panel of the power supply.
3. Pull the power supply out of the slot by its handle. There is slight resistance initially until the
power supply connectors disconnect from the slot connectors.
4. Set the power supply aside.
5. Check that the POWER switch of the replacement power supply is off.
6. Carefully insert the power supply into the tracks of the slot.
7. Slide the power supply into the slot until its front panel bottoms out on the chassis.
8. Tighten the two captive screws on the front panel of the power supply.
9. Turn on the POWER switch of the power supply.
Special Considerations
In the rare instance that the Pwr On indicator does not light and/or the Failure indicator does
light, reseat the power supply in its slot by using the preceding instructions. If the Pwr On
indicator still does not light and/or the Failure indicator is still lit, the power supply has failed and
you should contact your authorized field service representative.
2-22 Xedge 6000 Hardware
Installation & Setup Guide
Xedge 6280 Chassis
032R440-000
Issue 17