Table of Contents
Advertisement
Xedge Chassis Systems
Xedge 6002 Connections
The Xedge 6002 chassis provides connectors for power sources, management and grounds. The
following paragraphs describe how to make these connections. Note that the Xedge 6002 chassis
does not support contact alarm connections.
AC Power for Domestic Sites
For domestic deployments (U.S. and Canada), the Xedge 6002 AC chassis is equipped with one AC
power cord (US 120 VAC). Plug the appropriate end into the AC receptacle of the power input
module and plug the other end into a polarized outlet that provides the required AC power.
The AC power source should not be under switch control. If the Xedge 6002 is connected to other
equipment, it should be powered by the same AC source as that equipment to prevent large
circulating currents induced by differences in ground potential. If it is impossible to determine
whether the equipment is powered by the same AC source, verify that a potential difference of less
than 0.25 V rms exists between the grounding circuits of the respective power outlets.
AC Power for International Sites
For international deployments, the table below lists countries where the Xedge 6002 chassis can be
deployed with a customer-supplied AC power cord. Contact your Xedge representative for details.
Austria
Australia
Belgium
Brazil
Bulgaria
Cyprus
Czech Republic
Denmark
Estonia
Finland
032R440-000
Issue 17
France
Luxemburg
Germany
Malta
Greece
Mexico
Israel
Netherlands
Italy
Norway
Latvia
Poland
Lithuania
Portugal
Hong Kong
Rumania
Hungary
Russia
Ireland
Saudi Arabia
Xedge 6000 Hardware
Installation & Setup Guide
Xedge 6002 Chassis
Singapore
Slovakia
Slovenia
Spain
Sweden
Switzerland
Turkey
United Kingdom
2-5
Advertisement
Table of Contents
