Table of Contents
Advertisement
V7.x Packet Controllers
PCE Hardware Settings
To LIM1
S1
1
MGMT
5
Table 4-6
PCE Controls and Indicators
Items
Designation Description
Front Panel
FLT LED
Status LEDs
RUN LED
LNK FLT
Front Panel
MGMT
Ports
USB
FE
GbE Fiber
GbE Copper Two autorate Ethernet electrical ports
On-board
P3
Jumper
On-board
S1
(See
Rotary Switch
Figure
4-5)
(16-position)
Note
IMPORTANT ! Be aware that when S1 is set to F, all user configuration files and XOS code will be erased
from the card. This setting should be used with caution, and you must reset S1 back to 0, 4 or 8 immediately
after reboot to prevent inadvertent erasure with subsequent reboots.
Note
Additional S1 settings can be used to reboot the card to kernel for troubleshooting purposes, under the
guidance of your authorized Xedge field service representative.
4-16
To LIM2
To Switch
Fabric
LPM-CE
Daughter Card
3
P4
1
FE
4
GbE Copper
GbE Fiber
1
2
1
8
FLT (red) is normally off; Lit when a problem prevents the Slot Controller from functioning.
RUN (green) illuminates when the Slot Controller is powered on and operating.
LNK FLT (red) is not supported in this release.
10/100 8-pin modular jack connects to Prosphere Server or ProSphere Server network.
Serial craft port 19.2K Async 8N1)
Six Fast Ethernet ports (3 - 8) for 10/100 Mbps user traffic.
Two FE ports (1-2) used internally for serial-to-packet adaptation.
Two SPF ports for optical 1000 Mbps ports, or electrical 10/100/1000 Mbps ports.
Only for use in factory tests. For normal operation, this jumper must be set to
Pins 2 and 3, as shown above.
Set to 0 when PCE is in main slot 0 and slot 1 of Xedge 6160/6280.
Set to 0 when PCE is in standby slot 0 and slot 8 of Xedge 6640/6645.
Set to 8 when PCE is in non-slot 0 of any chassis (slot 0 must be a packet controller).
Set to F to delete all user-defined configuration files and XOS code (i.e. to factory default)
Xedge 6000 Hardware
Installation & Setup Guide
PCE Controller Overview
To
Backplane
USB
2
Backplane Connectors
PCE Base Card
PCE Front Panel
032R440-000
Issue 17
Advertisement
Table of Contents
