Front/Rear Panel Features - General DataComm Xedge 6000 Series Hardware Installation

Xedge Chassis Systems

Front/Rear Panel Features

The front of the Xedge 6160 chassis can hold one switch fabric module and up to four slot controller
modules (slots 0 through 3). The Xedge 6160 is supplied with an electrostatic discharge (ESD) wrist
strap that attaches to the front panel jack on the chassis.
The rear of the chassis can accept up to four LIMs and one System Management Module (SMM),
which provides two management (CRAFT) ports. There are two slots for Power Supply Units (main
and optional) that can provide power supply redundancy. The Power Input connector is not field
replaceable.
Mounting
Brackets
Figure 2-2
Note
IMPORTANT! All empty slots must have blank panels installed and the Power Input Modules must be
installed at all times to maintain proper chassis cooling, EMI shielding, ESD protection, and safety
requirements.
Note
One rear panel slot is intended for the SMM. Refer to Chapter 7, System Management Modules for details
2-10
Front View
SLOT 3 Slot Controller Module
SLOT 2
Slot Controller Module
SLOT 1 Slot Controller Module
SLOT 0 Slot Controller Module
Switch Fabric
POWER SUPPLY
OPTIONAL
PIM
POWER SUPPLY
MAIN
Rear View
Xedge 6160 Chassis, Front and Rear Views
Xedge 6000 Hardware
Installation & Setup Guide
Xedge 6160 Chassis
3
2
1
ESD
Strap
0
SF
SLOT 3 LIM
SLOT 2 LIM
SLOT 1 LIM
SLOT 0 LIM
SMM
Connector for
Antistatic Wrist Strap
032R440-000
Issue 17