Xedge 6002 Maintenance - General DataComm Xedge 6000 Series Hardware Installation

Xedge Chassis Systems

Xedge 6002 Maintenance

Fan Filter Maintenance
The Fan Filter Assembly is mounted on the left side rail of the chassis. The filter material should be
checked regularly for debris and tears. Replace clogged or damaged filter as described below:
1. At the left corner of the chassis front panel, loosen the screw and retaining block assembly.
2. Pull the tab to remove the Fan Filter Assembly. Check the filter material for dirt and wear.
3. If necessary, install a new Fan Filter Assembly. Do not attempt to clean the filter material, as
this will disrupt filtering and anti-static properties.
4. Tighten the screw and retaining block assembly into position.
Fan Tray Removal & Replacement
The Fan Tray Assembly is mounted on the right side rail of the chassis. In the event of a fan failure,
replace the entire assembly with a spare that has the same number of fans, as described below.
Individual fans should only be replaced by a qualified service engineer.
1. If one or more fans have failed, power down the chassis at once from the rear power panel.
Disconnect ESD Wrist Strap from the front panel, if connected.
2. At the right corner of the chassis front panel, loosen the screw and retaining block assembly.
3. Pull the tab to remove the Fan Tray Assembly. Your chassis may have two or four fans
mounted on the tray. Do not add or remove fans from the tray. Replace with a new Fan Tray
Assembly that has the same number of fans, unless instructed otherwise by a service engineer.
4. Tighten the screw and retaining block assembly into position, then power up the chassis.
Table 2-4 Xedge 6002 Fan Accessories
Description
Fan Filter Assembly
Fan Tray Assembly with 4 fans
Fan Tray Assembly with 2 fans
2-8
Ordering Part Number
010E502-001
200C009-001
200C009-002
Xedge 6000 Hardware
Installation & Setup Guide
Xedge 6002 Chassis
032R440-000
Issue 17