Table of Contents
Advertisement
Switch Fabric and V6.2 Controllers
XM Switch Fabric Module
The XM Switch Fabric module can control up to four slot controllers and is intended for use in the
Xedge 6160 desktop system. The XM operates at 50 MHz only (XH mode). The front panel LEDs
on the XM can be set to operate in three different display modes by setting jumper JP 2.
The jumpers on the XM Switch Fabric must be configured or checked before installing the module
in the chassis.
on each jumper. Hold the board as shown with the component side facing you and the front panel
to the left. In this position, references to "upper" or "lower" in the table are the "upper" or "lower"
jumper positions.
FRONT PANEL
Figure 3-5
032R440-000
Issue 17
Figure 3-5
and
Table 3-6
XM CIRCUIT BOARD
JP1
JP2
XM Jumper Locations
Xedge 6000 Hardware
Installation & Setup Guide
show the location and describe the function of pin pairs
Switch Fabric Setup
LEGEND
Jumper in upper position.
Jumper in lower position.
3-11
Advertisement
Table of Contents
