Reassembly - Motor And Pump - Mercury 150 EFI Service Manual

POWER TRIM

Reassembly - Motor and Pump

NOTE: Drive shaft is a loose part and may fall out of position.
1. Install pump onto power trim manifold. Insure O-rings are in proper locations. Secure
with two (2) screws. Torque screws to 80 lb. in. (9 N·m).
IMPORTANT: Install pump with location flat facing towards starboard transom
bracket.
a -
b -
c -
d -
2. Fill pump with Quicksilver Power Trim and Steering Fluid prior to installing motor.
3. Install motor, secure with two (2) screws. Route wiring; refer to Wiring Diagrams in this
service manual.
Page 5B-46
c
c
a
a
Pump (Flat Towards Starboard Transom Bracket)
Flat - Faces Starboard Transom Bracket)
O-rings (4)
Drive Shaft (Install in Center Hole in Pump)
d
d
b
b
c
c
51433
90-883728 JULY 2001