Dialing With Sub-Address - Toshiba DP80F Operator's Manual

Dialing with Sub-Address

This function attaches a sub-ad-
1
dress to the standard destina-
tion address in the event the re-
mote party requires one.
Load the document face down
Three types of sub-addresses
in the Document Support (see
can be used (SUB, SEP, and
page 82).
PWD); or any combination of
two or three types can be used.
Adjust the resolution and con-
After selecting the desired
trast if desired (see pages 83
types, the transmission to follow
and 84).
will be sent to the desired ad-
dress using the designated sub-
address.
You can activate this option
while programming an Abbrevi-
ated Dial Number (page 65) or
One Touch Dial Key (page 71) if
communication with a certain re-
mote party always requires this
option.
If you activate this option using
both an Abbreviated Dial Num-
ber (or One Touch Dial Key)
setting and using this procedure
for the same destination, this
operation will take precedence
over the pre-programmed set-
ting in the Abbreviated Dial or
One Touch Dial.
NOTE:
For more information on
when to use SUB/SEP/PWD,
refer to page 69. If you des-
ignate an erroneous or un-
necessary sub-address, the
communication will result in
an error.
Display the SUB
2
Load the Document
ADDRESS COMM
Menu
Press:
MAY-17 09:43 AM 100%
AUTO RECEIVE
SUB ADDRESS COMM.
1.DONE
2.SUBADDRESS SUB
3.SUBADDRESS SEP
3
Select the Option
Select one of the following op-
tions from the menu.
To select SUB, press:
+
Go to Step 4.
+
To select SEP, press:
+
Go to Step 5.
+
To select PWD, press:
Go to Step 6.
To complete this procedure,
press:
4.SUBADDRESS PWD
Go to Step 7.
4
Enter the SUB
Address
Enter the required SUB address
(max. 20 digits), then press:
The display returns to the
screen at the bottom of Step 2.
You may continue from Step 3
and enter another sub-address
of a different type. To complete
your sub-address entry, select
option "1.DONE" in Step 3.
173