Priming The Needle Wash Pump - Waters 717plus Operator's Manual

3.5 Priming the Needle Wash Pump

To prime the needle wash pump:
1. Ensure that the needle wash supply line (green) is in the solvent bottle and the
waste line (yellow) is in an appropriate container.
2. To prime the needle wash, press the keys outlined in the flowchart below
(Figure 3-7).
3
3. If, after 30 seconds, the solvent does not flow out of the waste line, press
NdlWash again.
59 Startup and Configuration
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Main Page
Diag
Page
Diagnostic Menu
Page
UserMaint
User Maintenance
Page
NdlWash
Page
Prime Needle
Wash Page
Start
NdlWash
Figure 3-7 Priming the Needle Wash Pump
Page
Start