Startup And Configuration; Powering Up The Autosampler; Power Switch Location - Waters 717plus Operator's Manual

3
Startup and Configuration
This chapter provides procedures for starting up, calibrating, configuring, verifying, and
powering down the Waters 717plus autosampler.

3.1 Powering Up the Autosampler

Note: If the 717plus autosampler is part of an IEEE-488 system, power up the 717plus
autosampler before powering up the system controller.
Powerup
To power up the 717plus autosampler:
1. Press the 1/0 (on/off) switch
Waters 717plus
Figure 3-1 Power Switch Location
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
(Figure 3-1) on the front panel.
Autosampler
Power Switch
Home
Display
Contrast
2
1 3
4
5 6
7 8 9
0 Clear
Enter
O I
MILLIPORE
Powering Up the Autosampler
3
50