Removing The Fuse Block; Fuse Installation - Waters 717plus Operator's Manual

Screw
Mount Shoulder
2
2. Orient the fuse block for the desired voltage
• For single 1/4-inch x 1 1/4-inch fuse arrangements, install the fuse block with
the fuse and jumper bar facing away from the cover.
• For dual 5 mm x 20 mm fuse arrangements, install the fuse block with the two
fuses facing away from the cover.
3. Install the appropriate fuse or fuses as labeled on the rear panel near the power
cord connector.
4. Ensure that the assembly is seated against the shoulder of the screw mount and
tighten the Phillips screw.
5. Install the fuse block and cover in the rear panel of the autosampler. Make sure
that the indicator pin fits through the appropriate opening on the left end of the
cover.
28 Installation
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
1. Loosen retaining screw.
Figure 2-4 Removing the Fuse Block
Single
Dual 100/120 Fuse
220/240 Fuse
Configuration
Configuration
Figure 2-5 Fuse Installation
2. Push clip.
3. Tilt up and slide
away from screw.
(Figure 2-5) as follows: