Connecting Rs-232 Output To Data Module; Ieee-488 Connections - Waters 717plus Operator's Manual

2
Waters 717plus
Setting IEEE-488 Addresses
In order to interact with the PowerLine system controller or LAC/E, each device on the
IEEE-488 communications bus must have a unique individual address.
Note: To use the autosampler on the IEEE-488 network, change the autosamplers
IEEE-488 address (refer to

2.5.3 Connecting RS-232 Output to Data Module

The RS-232 connector on the rear panel allows the autosampler to transfer injection
parameters to a data integrator such as the Waters™ 746 Data Integrator.
You may use the RS-232 port with any device that can read ASCII code.
To connect to the RS-232 port, plug the cable into the modified phone jack connector on
the rear panel of the Waters 717plus autosampler.
40 Installation
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Data System or
System Controller
IEEE-488
Network Cable
Autosampler Equipped with IEEE-488
Figure 2-10 IEEE-488 Connections
Section 3.6.2, Setting Parameters for LC System
Waters Detector
Operation).