Installing The Large Sample Loop; Installing The Temperature Probe - Waters 717plus Operator's Manual

Figure 2-14 Installing the Temperature Probe
7. Attach the temperature probe connector to the main circuit board. The
temperature probe connects to the main circuit board at J18, located to the lower
right of the battery (see
8. Replace the autosampler cover (see
717plus Cover) and reconnect the power cord.

2.6.3 Installing the Large Sample Loop

To inject sample volumes greater than 200 µL, you must install the auxiliary loop.
Caution: To avoid the possibility of electric shock, disconnect the autosampler power cord
before continuing this procedure.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Carousel Drive
Temperature Probe
Figure 2-13).
Section 2.6.1, Removing/Replacing the
Changing the Hardware Configuration
2
47