Table of Contents
Advertisement
AS-i 3.0 PROFINET Gateway in Stainless Steel
Installation
6.
Installation
6.1
Dimensions
Warning!
Cover the top of the gateway when doing any drilling work above the unit. No particles,
especially metal chips, should be allowed to enter the housing, since this could cause a
short circuit.
Information!
Please refer to installation instruction for this device for detailed mounting information.
6.2
Connections
10
10
AWG
6.3
Installing in the control cabinet
The AS-i PROFINET Gateway is installed in the control cabinet on 35mm DIN
rails per DIN EN 50 022.
Information!
The enclosure of the AS-i PROFINET Gateway is made of stainless steel. The unit is
also suitable for exposed wall mounting.
To install, place the unit on the upper edge of the DIN rail and then snap in the
lower edge.
12
55
75
7
85
2
0,2 ... 2,5 mm
2
0,2 ... 2,5 mm
24 ... 12
120
Advertisement
Table of Contents
Need help?
Do you have a question about the AS-I 3.0 PROFINET and is the answer not in the manual?
Questions and answers