Installing In The Control Cabinet; Removing - Pepperl+Fuchs VBG-PN-K30-DMD-S16-EV Manual

AS-i 3.0 PROFINET Gateway with integr. Safety Monitor
Installation
7.3

Installing in the control cabinet

The AS-I/Gateway is installed in the control cabinet on 35mm DIN rails per DIN
EN 50 022.
Information!
The enclosure of the
table for exposed wall mounting.
To install, place the unit on the upper edge of the DIN rail and then snap in the
lower edge.
+ -
7.4

Removing

+ -
To remove, press the holding clamps [2] down using a screwdriver [1], press the
unit firmly against the upper rail guide and lift out.
30
AS-I/Gateway
+ - + -
+ - + -
is made of stainless steel. The unit is also sui-
[1]
3
[2]
1
2