Complete The Procedure; Lcc Replacement; Identify The Failed - EMC Data Domain DS60 Hardware Manual

Complete the procedure

LCC replacement

Identify the failed

# alerts show current
Id Post Time
---- ---------------------- --------
p0-94 Mon Jun 1 9:46:27 2015 WARNING
2.
# enclosure show powersupply 11
This command may take up to a minute to complete. Please wait...
Enclosure Description
--------- ---------------------
4 Power module A pack 1
4 Power module A pack 2
4 Power module A pack 3
4 Power module A pack 4
4 Power module B pack 1
4 Power module B pack 2
4 Power module B pack 3
4 Power module B pack 4
--------- ---------------------
Procedure
1. Return the failed or replaced part(s) to EMC Data Domain. Reuse the packaging
from the new part(s) and use the included prepaid waybill for shipping.
Reference the RMA number on the outside of the package.
2. Send an autosupport report from the system by entering the autosupport
send command.
This procedure describes how to remove and replace an LCC.
Procedure
1. Check the rear of the shelf for the service LED of the affected .
Note
If the needs to be replaced, the service LED is a solid amber.
2. Log in as sysadmin.
3. Enter the alerts show current command to display messages indicating
failure. A sample output is shown.
Severity
4. Enter the enclosure show controllers command to find the failed
controller 9:
# enclosure show controllers 9
Encl 9
Model
Capacity
WWN
Serial #
Number of Controllers
Class Object
------- ---------
HWFailure Enclosure=9
Removing and Replacing FRUs
Status
------
OK
OK
OK
OK
OK
OK
OK
OK
------
Message
-----------------
EVT-MPATH-00006:
Path redundancy is lost.
Enclosure 9 only has
1 active connection path
and the required number is
60 Slots
N/A
APM00151918344
1
Complete the procedure
83