Avaya J100 Series Installing And Administering page 32

Initial setup and connectivity
VLAN parameters
The following configuration parameters are used to configure VLAN functionality on the network
switch internal to the phone.
Parameter name
L2Q
VLANTEST
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default value
0
60
setup
Comments on this document? infodev@avaya.com
Description
Specifies the VLAN tagging is
enabled or disabled.
Value operation:
• 0: Auto. VLAN tagging is turned
on when the network can
support VLAN tagging and
L2QVLAN is non zero.
• 1: On. VLAN tagging is turned
on when the network can
support VLAN tagging. The IP
phone sends tagged frames
with VLAN = L2QVLAN, even if
L2QVLAN is set to 0.
• 2: Off. VLAN functionality is
disabled.
L2Q is configured through:
• Local admin procedure
• A name equal to value pair in
DHCPACK message
• SET command in a settings file
• DHCP option 43
• LLDP
Specifies the number of seconds
that the phone waits prior to
failing back to a different VLAN ID
if no response is received from
the DHCP server.
Valid values are 0 through 999.
Value operation:
• 0: The phone continues to
attempt a DHCP REQUEST
forever.
VLANTEST is configured through:
• Settings file
Table continues...
32