Avaya J100 Series Installing And Administering page 143

Parameter name
HTTPSRVR
I
INGRESS_DTMF_VOL_LEVEL
INTER_DIGIT_TIMEOUT
IPV6DADXMITS
IPV6STAT
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
Null
-12dBm
5
1
0
setup
Comments on this document? infodev@avaya.com
Appendix A: List of configuration parameters
Description
name format, optionally followed by a
colon and a TCP port number.
The value can contain 0 to 255
characters.
Specifies zero or more HTTP server IP
addresses to download configuration
script files. The addresses must be
separated by commas without any
intervening spaces. The format of
specifying IP addresses are:
• Dotted decimal
• Colon-hex
• DNS name
The parameter can be set by using
LLDP.
Valid values contains 0 to 255 ASCII
characters.
Specifies the power level of tone,
expressed in dBm0.
Values can range from -20dBm to
-7dBm.
Specifies the number of seconds that
the phone waits after a digit is dialed
before sending a SIP INVITE.
Valid values are 1 through 10.
Specifies whether Duplicate Address
Detection is performed on tentative
addresses, as specified in RFC 4862.
Value operation:
• 0: DAD is disabled
• 1 to 5: Maximum number of
transmitted Neighbor Solicitation
messages.
Specifies whether IPv6 will be
supported or not.
Value operation:
• 0: IPv6 will not be supported.
Table continues...
143