Avaya J100 Series Installing And Administering page 176

Appendix
Parameter name
WBCSTAT
WEB_ADMIN_PASSWORD
WEB_HTTP_PORT
WEB_HTTPS_PORT
WEBSERVER_ON_HTTP
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
1
27238
80
443
0
setup
Comments on this document? infodev@avaya.com
Description
with 8-bit samples at 8kHz to be used
as a call recording warning instead of
the built-in English warning.
The value can contain 0 to 255
characters.
Specifies whether a wideband codec
indication is displayed when a
wideband codec is used.
Value Operation
0: Disabled
1: Enabled
Specifies the password to access the
phone through a web browser as an
administrator.
The value set from the web server
interface has a higher priority than that
of the Settings file.
If the Web admin password is
changed using the web server, then
the web admin password set through
settings file is not used until either the
web admin password is set to default
through the phone admin menu or the
phone is reset to default.
Valid values are from 8 to 31
alphanumeric characters including
upper, lower and special characters.
Specifies the port on which the Web
Server running on the phone will be
accessed using HTTP.
Valid values are 0, 80, 1024 to 65535.
Specifies the port on which the Web
Server running on the phone will be
accessed using HTTPS.
Valid values are 443, 1024 to 65535.
Specifies whether HTTP access to the
web server is enabled or disabled.
Value operation:
• 0: Web Server is not accessible
through HTTP.
Table continues...
176