Setting The Group Identifier; Setting Event Logging - Avaya J100 Series Installing And Administering

Setting the group identifier

About this task
Use this procedure to set or change the group identifier only if the LAN Administrator instructs you
to do so.
Procedure
1. Press Main Menu > Administration.
2. In the Access code field, enter the admin menu password.
3. Press Enter.
4. Select Group.
5. Enter any Group value between 0 to 999.
When you change the Group value, the phone restarts after you exit the admin menu.
6. Press Save.
Related links
Group identifier on page 96

Setting event logging

Procedure
1. Press Main Menu > Administration.
2. In the Access code field, enter the admin menu password.
3. Press Enter.
4. Select Log.
5. Use the Right and Left Arrow keys to select one of the following settings associated with
the corresponding SYSLOG_LEVEL:
• Emergencies: SYSLOG_LEVEL=0
• Alerts: SYSLOG_LEVEL=1
• Critical: SYSLOG_LEVEL=2
• Errors: SYSLOG_LEVEL=3
• Warnings: SYSLOG_LEVEL=4
• Notices: SYSLOG_LEVEL=5
• Information: SYSLOG_LEVEL=6
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
setup
Comments on this document? infodev@avaya.com
Setting event logging
97