Installing the Wireless Module
Before you begin
Get the following items:
• Phillips #1 screw driver to install the screw of the J100 Wireless Module.
• A flat screw driver that fits in the opening of the module panel.
Procedure
1. Insert the screw driver in the opening of the module panel to release the latch. Do not pry
open the panel.
2. To remove the module panel, slide the panel out in the direction of the arrow.
August 2018
Installing and Administering Avaya J100 series IP Phones in third-party call control
setup
Comments on this document? infodev@avaya.com
Hardware setup
15