Avaya J100 Series Installing And Administering page 157

Parameter name
PLAY_TONE_UNTIL_RTP
POE_CONS_SUPPORT
PRESERVED_CALL_DURATION
PROCPSWD
PROCSTAT
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
1
120
27238
0
setup
Comments on this document? infodev@avaya.com
Appendix A: List of configuration parameters
Description
Specifies whether locally-generated
ringback tone stops as soon as SDP is
received for an early media session, or
whether it will continue until RTP is
actually received from the far-end
party.
Value Operation
• 0: Stop ringback tone as soon as
SDP is received.
• 1: Continue ringback tone until RTP
is received (default).
Enables power over Ethernet
conservation mode.
Value Operation
• 0: Power conservation mode is not
supported.
• 1: Power conservation mode is
supported.
Specifies the time interval in minutes if
ENABLE_IPOFFICE is set to 2 and if
MEDIA_PRESERVATION is set to 1 .
The time interval can be from 10
minutes to 120 minutes.
Specifies an access code to access
the admin menu procedures.
Valid values contain 0 through 7 ASCII
numeric digits. The default value is
27238 (CRAFT) unless indicated
otherwise below. A null value implies
that an access code is not required for
access.
Note:
Setting the value in this file is
intended primarily for
configurations with versions of
phone or if server software that
do not support setting this value
from the server.
Specifies an access code to access
the admin menu procedures.
Table continues...
157