Avaya J100 Series Installing And Administering page 146

Appendix
Parameter name
LLDP_ENABLED
LOCAL_DIAL_AREA_CODE
LOCAL_LOG_LEVEL
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
2
3
setup
Comments on this document? infodev@avaya.com
Description
Valid values can contain 0 to 1096
ASCII characters, including commas.
Filenames must end in .xml.
Specifies whether LLDP is enabled.
Value operation:
• 0: Disabled
• 1: Enabled
• 2: Enabled, but only begins
transmitting if an LLDP frame is
received.
Specifies if user must dial area code
for calls within same area code
regions.
Value Operations
• 0: User don't need to dial area code.
• 1: User need to dial area code.
When enabled, the area code
parameter (PHNLAC) should also be
configured.
Note:
This parameter is supported
when the phone is failed over.
Specifies the severity levels of events
logged in the endptRecentLog,
endptResetLog, and
endptStartupLog objects in the
SNMP MIB. Events with the selected
severity level and above are logged.
Lower numeric severity values
correspond to higher severity levels
Value Operation
• 0: Emergency events are logged.
• 1: Alert and Emergency events are
logged.
• 2: Critical, Alert and Emergency
events are logged.
Table continues...
146