Avaya J100 Series Installing And Administering page 24

Initial setup and connectivity
the administrator selects Yes in the prompt, the phone forces DES discovery and it overrides the
provision server provided by DHCP.
Related links
Phone installation process
Phone installation without DES
This section describes the procedure to install the phone without invoking the DES discovery
process.
Related links
Phone installation process
Prerequisites on page 24
Administration methods
Installation checklist
Phone deployment in third-party call control setup
Prerequisites
Check the prerequisites to ensure that you have the required software and hardware before you
install the Avaya J100 Series IP Phones.
Software requirements
Ensure that your network already has the following components installed and configured:
• A DHCP server for providing dynamic IP addresses to the Avaya J100 Series IP Phones.
• A file server, an HTTP or an HTTPS for downloading the software distribution package and
the settings file.
For more information about installing and configuring the components, see their respective
documentation.
Hardware requirements
Ensure that the LAN uses:
• Ethernet Category 5e or Ethernet Category 6 cabling.
• Either the 802.3at PoE or the 802.3af PoE injector specification.
Related links
Phone installation without DES
Administration methods
You can use the following methods to administer the devices. The following table lists the
configuration parameters that you can administer through each of the corresponding methods.
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
on page 23
on page 23
on page 24
on page 25
on page 24
Comments on this document? infodev@avaya.com
on page 26
setup 24