Avaya J100 Series Installing And Administering page 144

Appendix
Parameter name
K
L
L2Q
L2QAUD
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
Default
value
0
6
setup
Comments on this document? infodev@avaya.com
Description
• 1: IPv6 will be supported.
Specifies whether the VLAN tagging is
enabled or disabled.
Value Operation
• 0: Auto - VLAN tagging is turned on
when the network can support VLAN
tagging and L2QVLAN is non zero.
• 1: On - VLAN tagging is turned on
when the network can support VLAN
tagging. The IP phone sends tagged
frames with VLAN = L2QVLAN,
even if L2QVLAN is set to 0.
• 2: Off - VLAN functionality is
disabled.
Note:
This parameter can also be set
through:
• Local admin procedure
• A name equal to value pair in
DHCPACK message
• SET command in a settings file
• DHCP option 43
• LLDP
Specifies the value of the VLAN
priority portion of the VLAN tag when
the phone generates tagged Ethernet
frames from the internal CPU of the
phone. These values are inserted into
the VLAN tag for audio frames (RTP,
RTCP ). All other frames except those
specified by the L2QSIG parameter
are set to priority 0.
Valid values are 0 through 7.
Table continues...
144