Configure Ip Address (Ipv4) Settings - Polycom RealPresence Group Series Administrator's Manual

Setting
Control Priority
For more information about configuring LAN settings for Microsoft environments, see the Polycom Unified
Communications for Microsoft Environments Solution Deployment Guide at
Related Links
Configuring the Software

Configure IP Address (IPv4) Settings

You can configure IP address (IPv4) settings for RealPresence Group Series systems.
Procedure
1. In the system web interface, go to Admin Settings > Network > LAN Properties.
2. Configure the following IPv4 settings on the LAN Properties screen.
Setting
IP Address
Your IP Address is
Subnet Mask
Polycom, Inc.
on page 239
Description
Sets the link layer priority of control traffic on the wired
LAN. Control traffic consists of control information
associated with a call:
• H.323: H.225.0 Call Signaling, H.225.0 RAS, H.245,
Far-End Camera Control (FECC)
• SIP: SIP Signaling, FECC, Binary Floor Control
Protocol (BFCP)
This setting is available only when you enable
802.1p/Q. You can use any value from 0 to 7, although
Poly recommends not using 6 and 7.
Polycom
Description
Specifies how the system obtains an IP address.
• Obtain IP address automatically—Select if the
system gets an IP address from a DHCP server on
the LAN.
• Enter IP address manually—Select if the IP
address will not be assigned automatically.
If the system obtains its IP address automatically, this
area displays the IP address currently assigned to the
system.
If you selected Enter IP address manually, enter the
IP address here.
Displays the subnet mask currently assigned to the
system.
If the system does not automatically obtain a subnet
mask, enter one here.
Configuring Network Settings
Support.
61