Powering On The Realpresence Group 700 System; Navigating The System; Access The System Web Interface - Polycom RealPresence Group Series Administrator's Manual

Powering On the RealPresence Group 700 System

You can use the remote control or the power sensor to power off the RealPresence Group 700 system.
The RealPresence Group 700 system can be powered on and off with the remote using the same buttons
as shown for the other RealPresence Group Series systems; however, the RealPresence Group 700
system supports a low-power standard that limits the power supplied to the camera when the system is
powered off. So, if the EagleEye IV or EagleEye III camera is receiving its power only from the HDCI
connector attached to the system, it will not have an active IR receiver capable of powering on the system
using the handheld remote when in the Power Off state.
• Provide direct power to the EagleEye III or EagleEye IV camera with the optional EagleEye camera
power supply, 1465-52748-040. This allows the IR sensor to remain in a Power On state, so that the
camera is capable of receiving IR commands from the remote control.
• Position the RealPresence Group Series system so that the IR receiver on the front of the system
has a line-of- sight to the remote control.
• Use a third-party IR extender to extend the IR signal from the room to the IR receiver on the front of
the system.

Navigating the System

You can navigate the RealPresence Group Series system using the system web interface.

Access the System Web Interface

You can use the system web interface to perform many of the same calling and configuration tasks you
can perform on the local interface.
To configure your browser to use the system web interface, you must do the following:
• Use a supported browser.
• Configure your browser to allow cookies.
Login credentials are user IDs and passwords that identify the user and define the user's ability to access
the system. You can configure both local and remote access for users.
The system web interface supports the most commonly used web browsers. For a list of supported
browsers, refer to the Polycom RealPresence Group Series Release Notes at
Note: For security purposes, Polycom recommends that you follow best practices when logging into the
®
Polycom RealPresence
and do not browse the internet while logged in to the system.
Procedure
1. Enter the system IP address in a browser.
2. Enter the user name (the default is admin).
3. Enter the password, if one is set.
Related Links
Security Setting Management
Related Links
Run the Setup Wizard from a Remote Location
Polycom, Inc.
®
Group Series system web interface. Use an updated browser version
on page 17
on page 27
Getting Started
Polycom Support.
19