Adding A Polycom Soundstation Ip 7000 Conference Phone - Polycom RealPresence Group Series Administrator's Manual

• Connect one end of an HDMI cable to the HDMI Input port on the monitor. Connect the other
end of the HDMI cable to the Monitor 2 HDMI Output port on the system.
• If your monitor has only a DVI input port, use a DVI-HDMI adaptor to connect it to the HDMI
output port of the system.
2. Connect the touch monitor to the system.
If you are using a Polycom UC Board sensor with your current content monitor, the sensor is
connected to the system.
a. Connect one end of a USB cable to the USB port on the touch monitor.
b. Connect the other end of the USB cable to the USB port on the system.
A USB storage device can also be installed in the second USB port on the system for
importing and exporting slides, images, or photos.
3. To connect cables from the monitor 2 or the touch monitor to the system, refer to the next figure.
Adding a Polycom SoundStation IP 7000 Conference
Phone
When you connect a Polycom SoundStation IP 7000 conference phone to a RealPresence Group Series
system, the conference phone becomes another way to dial audio or video calls. The conference phone
also operates as a microphone, and as a speaker in audio-only calls. For more information, refer to the
following documents at Polycom
• Polycom SoundStation IP 7000 Conference Phone Connected to a Polycom RealPresence Group
System in Unsupported VoIP Environments Integration Guide
• Polycom SoundStation IP 7000 Conference Phone Connected to a Polycom RealPresence Group
System in Unsupported VoIP Environments User Guide
Polycom, Inc.
Support:
Setting Up System Hardware
26