Setting Up A Polycom Content Display Application; Download And Install Polycom ® People+Content ™ Technology - Polycom RealPresence Group Series Administrator's Manual

At Enable, select either Auto or Manual. If you chose Manual, select any of the available profiles,
except Content, then Far, then Near or Content, then Far.
3. To configure monitor 2, at Monitor Profile, enable one of the content profiles, such as Content,
then Far, then Near, Content, then Far, Content, then Near, or the Content Only profile.

Setting Up a Polycom Content Display Application

The People+Content IP application enables a presenter to show content from a computer to other sites in
a video conference using only an IP network connection. The presenter can show PowerPoint
video clips, spreadsheets, or any other type of content from a computer. People+Content IP supports any
computer desktop resolution with color set to 16-bit or higher.
If the system is paired with a RealPresence Touch or a Polycom Touch Control, People+Content IP does
not require installation. After you connect the PC to the USB connection on the device, a version of
People+Content IP launches automatically.
Before a presenter can use a computer to show content with People+Content IP, do the following:
• Download the People+Content IP software application from the Polycom web site to the computer
or computers that the presenter will use to show content.
You don't need to change the computer resolutions and you don't need special cables or hardware,
but each computer must meet these requirements:
◦ Operating System: Windows 7 or 8
◦ Minimum computer: 500 MHz Pentium
computer: 1 GHz Pentium III (or equivalent); 512 MB memory
• Connect the computer or computers to the IP network.
Download and Install Polycom
You need to download and install the Polycom
can use it to show content.
Note: If the room system is paired with a Polycom touch device, you do not need to install the
application onto your computer. After you connect your computer to the touch device over USB, a
version of the People+Content IP application launches automatically.
Procedure
1. On a computer, go to the
2. Download the People+Content IP software for Mac or PC.
3. Open the zip file and click the application installation.
4. Follow the instructions in the installation wizard.
Polycom, Inc.
®
III (or equivalent); 256 MB memoryRecommended
®
People+Content
®
People+Content
Polycom People+Content IP
Enabling Content Sharing
™
Technology
™
technology on a computer before you
page.
®
slides,
201