Table of Contents
Advertisement
Figure 62. Installing the rear drive cage
Next steps
1. Replace the
expansion card
2. Connect all the cables to the rear drive cage.
3.
Install all the
drives.
4. Follow the procedure listed in
Front PERC module
Removing the front mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
remove the backplane
cover.
4. If installed,
remove the air
5. Disconnect all the cables, observe the cable routing.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the front PERC module.
2. Slide and pull the front PERC module to disengage from the connector on the drive backplane.
84
Installing and removing system components
riser, if needed.
After working inside your system
Safety instructions
Before working inside your system
shroud.
on page 47.
on page 46.
on page 47.
Advertisement
Table of Contents
