Instruments And Instrument Hoses; Rinse Water Paths; Purge Water Paths (Purge Function) - Dentsply Sirona Sinius Operating Instructions Manual

5 Care, cleaning and maintenance by the practice team

5.3 Instruments and instrument hoses

max.
216
Instruments and instrument hoses
5.3
5.3.1

Rinse water paths

Microorganisms can grow in the water paths of the treatment center.
Use a large amount of water for rinsing the lines prior to starting patient
appointments.
➢ Flush the cuspidor for at least one minute.
5.3.2

Purge water paths (purge function)

To reduce the bacterial load, the water paths of the water-carrying
instruments of the dentist element and the Sprayvit M multifunctional
syringe of the dentist and assistant element can be purged with water.
For the purge function, individual instruments are removed from the
holder and held over the cuspidor for purging. If your treatment center is
not equipped with a cuspidor, hold the instruments over a watertight
container with sufficient capacity. The water paths of all removed
instruments are then purged simultaneously. Press the water key on the
Sprayvit M unit for purging.
It is also possible to purge the water paths automatically, see "Purging
water paths automatically (AutoPurge function)" [→ 219].
Preparation
The following preparations should be made before you begin to purge
the water paths.
1. If your treatment center is equipped with a cuspidor, activate the
cuspidor flushing for at least one minute. This flushes the water
paths.
2. Set all of the instruments to be purged to their maximum water flow
rate.
3. Put all instruments in place.
Opening the purging dialog
ü The Start dialog is displayed on the touchscreen.
1. In the Start dialog standard version : Touch the Sub-dialog key.
In the Start dialog simplified version : Press the Chair dialog change
key.
Dentsply Sirona
Operating Instructions Sinius
63 2 2 7 26 D3561
D3561.201.01.16.02 08.2018