Cup Holder - Dentsply Sirona Sinius Operating Instructions Manual

Dentsply Sirona
Operating Instructions Sinius
max.
1 kg
2.2 lbs
Sinius, Sinius TS
max.
1 kg
2.2 lbs
Sinius CS
63 2 2 7 26 D3561
D3561.201.01.16.02 08.2018
Adjusting the stiffness of the rotary joint
In the head of the tray holder there is a regulating screw for setting the
necessary exertion for turning the tray.
1. Remove the tray.
2. Grab under the front of the tray head cover with your fingers and
pull it up and off.
3. Turn the regulating screw to set the stiffness of the rotary joint.
Clockwise: Increase stiffness
Counterclockwise: Decrease stiffness
4. Put the cover back on the tray head. First put the nose on the rear
edge of the cover on the tray head. Then, fold the front of the cover
down until it locks in place.
4.8.4

Cup holder

A cup holder can be attached to the tray to collect waste. It is suitable
for disposable 0.2-liter cups.
For Sinius with sliding track and Sinius TS, the cup holder may not be
attached to the front edge of the tray.
The maximum load of the cup holder is 0.5 kg (1.1 lbs). The load on the
tray and the cup holder may not exceed a total of 1 kg (2.2 lbs).
max.
The cup holder can be ordered from a specialized dealer. Please note
0,5 kg
1 1 . lbs
the different tray systems:
Treatment center
Sinius (sliding track
device) and Sinius TS
Sinius CS
max.
0,5 kg
1 1 . lbs
Tray REF Cup holder REF
64 0 9 9 86 65 9 5 321
65 9 5 339
64 2 9 0 42 Holder for
two standard trays
64 2 9 0 59 Holder for 1
standard tray
4 Operation
4.8 Tray
167