Creating Chair And Shock Positioning Programs - Dentsply Sirona Sinius Operating Instructions Manual

Dentsply Sirona
Operating Instructions Sinius
63 2 2 7 26 D3561
D3561.201.01.16.02 08.2018
4.4.10

Creating chair and shock positioning programs

Chair programs
The four chair programs preset in the factory:
● Mouth rinsing position S
● Entry/exit position 0
● 1 and 2
can be individually reprogrammed for each of the six user profiles (A to F).
ü The Start dialog is displayed on the touchscreen.
1. Move the patient chair to the desired treatment position; see
"Moving the chair manually" [→ 77].
2. For motor-driven headrest: Tilt the headrest to the desired treatment
position; see "Inclining the headrest" [→ 72].
3. Switch the operating light on or off (this will be included in the
program), see "Operating light" [→ 170].
4. Press and hold the desired program key (S, 0, 1, 2) (> 2 s).
Ä An acoustic signal sounds. Your settings are now stored under
the desired program key.
Note: Chair programs S and 0 can also be programmed on the assistant
element side.
Shock positioning
When the Shock positioning key is pressed, the patient chair
immediately moves to a position suitable for shock positioning of the
patient.
The shock positioning position preset at the factory can be
reprogrammed.
1. Move the patient chair to the desired position.
2. Press and hold the Shock positioning key (> 2 s).
WARNING
Program this key exclusively for shock positioning the patient, never
use as a treatment position.
4 Operation
4.4 Patient chair
79