Foot Control; Wireless Foot Control; Setting The Wireless Foot Control On The Treatment Center; Battery Voltage Message - Dentsply Sirona Sinius Operating Instructions Manual

Dentsply Sirona
Operating Instructions Sinius
S
0
63 2 2 7 26 D3561
D3561.201.01.16.02 08.2018

Foot control

4.3
The treatment center can be operated using a wireless foot control or a
foot control with a cable connection.
4.3.1

Wireless foot control

Technical data of the wireless module, see Foot control radio interface"
[→ 27].
4.3.1.1

Setting the wireless foot control on the treatment center

The wireless foot control must be assigned to the treatment center via a
registration. This prevents malfunctions caused by neighboring wireless
foot controls.
ü The treatment center and wireless foot control are ready for
operation.
ü All instruments are in place.
1. Simultaneously press and hold the left and right buttons of the foot
control (> 2 s).
Ä An acoustic signal sounds. The following message appears on
the touch screen:
Ä If no key is touched, the screen will automatically close after a
specific time. The wireless foot control will not be registered.
2. Confirm that this wireless foot control is to be used on the treatment
center by pressing the OK button. The registration process can be
interrupted with the Esc key.
Ä The message is hidden. The wireless foot control is assigned to
the treatment center.
4.3.1.2

Battery voltage message

The wireless foot control is powered by a battery. An almost empty
battery is detected by the system and displayed in the status bar. In this
case, the battery should be replaced within a week.
When the battery is completely empty, an error code is output, see
"Error messages" [→ 267]. The symbol of the wireless foot control is
now displayed flashing. Replace the battery as soon as possible to
prevent system failure.
The battery can be changed by the user, see "Changing the battery of
the wireless foot control" [→ 262].
4 Operation
4.3 Foot control
61